How to Add/Change Pass Codes from Panel Programming

Issue

How are passcodes changed or added in the DS7090, DS7090i?

Solution

Enter Programming mode on panel by entering [Installer's code] + [#] [0]. (The default installers code is 9,8,7,6,5).

Enter address 84, the user number, authority code and passcode in the following format:

84,AA,B,CCCCC,#

84= address for passcodes

AA= User number 01-15

B= Authority level

0= Service Code, all privileges, always reports

1= Master Code, passcode changes, arm, disarm, force arm, bypass and system test

2= Arm, disarm, force arm, bypass and system test

3= Arm, disarm, force arm, bypass

4= Arm, disarm

5= Temporary code- Arm, disarm

6= Arm only, force arm and bypass

7= Arm only

8= Temporary code arm only

9= Access code. Operates Aux relay

#= Will delete this user's user code

CCCCC= a 1-5 digit passcode

B.) FROM MASTER CODE PROGRAMMING MODE:

1) Enter Master Code Programming Mode by entering [Master Code] + [#] [0]

2) Enter User number (01-15)

3) Enter Authority Level (See list above)

4) Enter the User Code + [#]

Notes

-Codes can be from 1 to 5 digits, it is recommended to use at least 3 digits.

-Codes can be turned off in Master Code Programming by entering the user code to be cancelled followed by [#]

Part numbers DS7090I, S7090TM, DS7090TMI, DS7090

BT Technical Knowledge Public