How to operate the 2000 series control panel.

Press 1

System Test Mode (Installer switch closed)

Close the Installer Switch and when the keypad responds with ‘System Trouble Press 4 to View’, Press (1) to enter System Test Mode.  The keypad will respond with Enter Code to Start Test. Enter the installer code (default=654) and the following menu options will display:

1)       Bell Test

2)       Battery Test

3)       Phone Test

4)       RF Programming

5)       Point Status (Press 5 and the first two points display, press the asterisk (*) to advance to next two points.  All points will display regardless if programmed.)

6)       Relay state

7)       Menu item (7) is not used

😎       Keypad programming

 Press the number corresponding with the desired menu option.

Press 2

Answer RPS

Press 3

Reset Sensors

Press 4

Check System Troubles

If system troubles are present, the keypad will respond with System Trouble Press 4 to View. Press 4 and the Call For Service text will appear.  Press and hold the 5 key and one or more of the following will appear:

1)       Low or Missing Battery

2)       Stand-By Switch Locked

3)       Aux Power Trouble

4)       Bell power Trouble

5)       Receiver # Tamper

6)       Receiver # Trouble (No Signals)

7)       Receiver # Trouble (Jammed)

Press 5

Change Passcode

Enter old code, enter new code, enter new code again, the keypad should respond with Code Changed.

Press 6

Show Passcode Type / Add Passcode

1. Enter Owner Code to modify codes

     1) Press 9 to renew one time codes

     2) Press 1 to change code types- Displays current code type. Responds with: Select Code (1-8). Select code and:

          1.       Select 1 for Owner

          2.       Select 2 for User

          3.       Select 3 for One-Time code

          4.       Select 4 for Disabled

     3) Press 0 to change code.  Responds with: Select Code (1-8). Enter new code. Enter new code again.

2.  Press 0 to change code.  Responds with: Select Code (1-8). Enter new code. Enter new code again

Note:  Adding passcodes is controlled in panel programming.  If pressing 6 or the code entered is not allowed check the panel program setting for Change Passcode.  

-  Disabled:  Passcodes cannot be changed from the keypad.

-  Owner: The function requires an owner type passcode.

-  Owner & User: Any owner or user passcode type may be used.

Press 7

Select Watch Tone 

Responds with: Enter Code to Change Tone. Select one of the following:

1. Off
2. Short Beep
3. Beep Till Key
4. Beep Till Closed

Press 8

Change Watch Points 

Responds with: Enter Code to Change Points.

Enter Point number + * to toggle watch mode on or off for points.

Press 9

All-On

Press 9,9

All-On with No Delay

Press 0

Part On

Press 0,0

Part-On with No Delay

Press /hold CLEAR key

Toggle backlighting ‘Always Illuminate’  / ‘Illuminate with keypress’