6026 How to access keypad programming the GV3 Panel.

Keypad programming is available in GV3 panels with firmware revision 8.10 or higher. 

NOTE: Keypad programming is not available during while an RPS programming session is active, or when any area is armed.

Enter from normal operation:

1. Press [9]+[9]+[Enter].
2. Select Keypad Programming. The keypad displays Enter Passcode.
3. Enter the service passcode (default= 123).

Enter from service mode (reset pin closed):

1. D1255:
   1. Set the address to 16 with dipswitch: 1-5= OFF and 6= ON. The keypad displays Enter Passcode when the reset pin is closed.
   2. Enter the service passcode (default= 123).
2. D1260:
   1. Set the address to 8 with dipswitch: 1-3= OFF and 4-6= ON. The keypad displays Enter Passcode when the reset pin is closed.
   2. Enter the service passcode (default= 123).

The following options are available upon entering keypad programming:

• Phone Numbers – Phone 1 thru Phone 4
  • Phone Format - Phone 1 thru Phone 4
  • Enhanced Comm – Path 1 thru 4
• Routing
  • Route Groups 1 thru 4
• RPS Parameters
  • RPS Passcode
  • RPS Phone Number
  • RPS IP Address
  • RPS IP Port
• Area Parameter – 1 thru 32
  • Account On – Yes / No
  • Account Number
• Command Center 1 thru 16
  • Enhanced Command Center – Yes / No
  • Command Center Scope –
• User Pass Code
  • User 0 (Install Passcode)
  • User 1 (User Passcode)
• Point Parameters
  • D9412GV3: 1-247
  • D7412GV3: 1-75
  • D7212GV3 1 -40
  • Point Index
• Disable Keypad Programming