Overview: D4112 doesn’t arm or anything when code is entered at the keypad.
Issue
Nothing happens. Doesn’t arm or anything when code is entered at the keypad.
Solution
- Connect programmer using coiled cord.
- Plug in plastic RJ phone type plug into COMMUNICATOR female connector on 5200
- Plug brown connector on other end of coiled cord to programmer connection on 4112
- Press ON button on 5200
- Type in password at PASSWORD prompt, press enter.
- Top Line of 5200 shows PRODUCT HANDLERS
- Using the up/down arrows scroll down until 4112. Please blinking cursor on 4112
- Press RED Enter Group button
- Place cursor on NEWRECORD
- Short the Standby pin on 4112 to ground momentarily
- Press RECV(COPY) button on programmer
- Receiving will be displayed at the top line of the 5200 Display
- Scroll down using arrow down key until cursor is on 2 PASSCODES
- Press ENTER GROUP button
- Passcode1 should have 234 in the field.
- To change field, press CLEAR key and type in the code to be used.
- Press enter
- The code is restricted to 4 characters but the user enters a prefix of 1, 2, 3, 4, 5…depending upon the slot. Example: PASSODE1 shows 234. The user code will be 1234
*** NOTE: Also make sure that the panel has a valid and functioning analog line. The functionality of the system is dependent upond successful communications.
