| Scroll ignore |
|---|
| Scroll ignore |
|---|
Link to be provided outside of Bosch Internal document. This article cannot be provided outside of Bosch. |
Step-by-step guide
Steps to focusing a Box camera:
- Start by opening the Lens Wizard in the Installer Menu
- Set the Back Focus to the Center position
- By pressing Center Button
- When the Focus position is finished it will be centered at 500.
- Set the Zoom manually (Wide to Tele) to customize the image boundaries.
- Then focus the lens manually
- By physically adjusting the focus on the lens body.
- Adjust the manual lens focus as good as physically possible.
- Finally, press ‘Full Range’ to allow the camera to auto focus for the optimum image focus.
- By pressing Center Button
- The objective is to have the camera's focus position set near the Focus Position of 500 position.
- If the focus position is off center like the below image, the camera/lens could have problems focusing from edge to edge.
- The objective is to have the camera's focus position set near the Focus Position of 500 position.
- To focus on a specific area
- Select the area by dragging the Rectangle to shade the specific area that you want to focus.
- Then press Local Range to focus on the specific area.
- To focus on a specific area
| Note | ||
|---|---|---|
| ||
The Box camera can also experience problems with focus when the tilt of the camera and the tilt of the lens react together to create focus limitation.
|
| Scroll ignore |
|---|
Information below is for CTS, SG, GK reference and must be kept internal only. If you are part of CTS, SG or GK team, please hide this section when you have finished using this article! |
| Scroll only | ||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| ||||||||||||||
You are using an Offline Version of these Article, please ensure to regularly check the corresponding online article on the Bosch Building Technologies Knowledge Base for any updates. Use the date and version information of the document as reference. This is |