Issue
How is the DX2010 point expander addressed to use points 9-16?
Solution
Points 9-16 use address 102 for the DX2010.
Use the table below to configure the DX2010’s address. Refer to the control/communicator’s installation manual to determine the appropriate address for each DX2010 you connect.
Each time you change the address DIP switches,cycle the power to the DX2010 (turn the power offand then on) for the address change to take effect.
101 OFF OFF OFF OFF OFF OFF 117 OFF ON OFF OFF OFF OFF
102 OFF OFF OFF OFF OFF ON 118 OFF ON OFF OFF OFF ON
103 OFF OFF OFF OFF ON OFF 119 OFF ON OFF OFF ON OFF
104 OFF OFF OFF OFF ON ON 120 OFF ON OFF OFF ON ON
105 OFF OFF OFF ON OFF OFF 121 OFF ON OFF ON OFF OFF
106 OFF OFF OFF ON OFF ON 122 OFF ON OFF ON OFF ON
107 OFF OFF OFF ON ON OFF 123 OFF ON OFF ON ON OFF
108 OFF OFF OFF ON ON ON 124 OFF ON OFF ON ON ON
109 OFF OFF ON OFF OFF OFF 125 OFF ON ON OFF OFF OFF
110 OFF OFF ON OFF OFF ON 126 OFF ON ON OFF OFF ON
111 OFF OFF ON OFF ON OFF 127 OFF ON ON OFF ON OFF
112 OFF OFF ON OFF ON ON 128 OFF ON ON OFF ON ON
113 OFF OFF ON ON OFF OFF 129 OFF ON ON ON OFF OFF
114 OFF OFF ON ON OFF ON 130 OFF ON ON ON OFF ON
115 OFF OFF ON ON ON OFF 131 OFF ON ON ON ON OFF
116 OFF OFF ON ON ON ON 132 OFF ON ON ON ON ON
ON indicates the DIP switch is in the ON position; OFF indicates the DIP switch is in the OFF position.
Part number D6412, D4412, DX2010
