What to consider when using the NDA-3080-CND Conduit adapter for DINION inteox 7100i IR installation?

Loading

Question

When using the conduit adapter NDA-3080-CND for the installation, be sure to:

For protection against water ingress we recommend to avoid top entry for the conduit adapter and use the side and bottom entry position
Mark the position of the hole of the surface
Drill the hole with the appropriate diameter drill
Install a plug in the hole
Put the cable through the hole of the conduit plate
Attach the conduit plate with the conduit plate adapter to the surface
Install the conduit cover on the conduit plate. Tighten the two screws with the TR15 Allen key

NDA-3080-CND:

RJ45 punch-through aid (→ , & )

Put the RJ45 punch-through aid on the network cable and use it to go through the rubber grommet
Do the same process for the power cable and punch through the rubber grommet

Mount it

Fix the rubber grommets in both cables inlets and make sure that the cable inlets are firmly closed. Mount the wall plate to the conduit adapter NDA-3080-CND

Wall plate

Compatibility with various existing mounting options

Other useful information:

Cable management
- Connect the Ethernet cable to the unit
- Connect the power cable in case no PoE is used
Installing the camera base
- Mount the unit on its base
- Tighten the four screws
Angle adjustment
- Using the Allen key, you can loose the camera articulation nuts to adjust the view angle of the camera towards the desired area
- Always you need to tighten the nuts after positioning the camera as desired
Tilt angle
- The unit has three flexible joints used for defining camera position and view angle
Adding a Micro SD card
- You need to move the sun shield forward to the max position, in order to get access to the Micro SD card slot
- Note: You will find the Reset button here as well