| Warning | ||
|---|---|---|
| ||
Do not remove power to the unit during a factory default. Wait at least two minutes for the default process to complete. |
Step-by-step guide
- Type in the camera IP address in a web browser
- Authenticate on the camera with its credentials
- Go to CONFIGURATION > CAMERA > INSTALLER MENU, then select Factory Defaults.
A confirmation screen appears. Allow several seconds for the camera to optimize the picture after a reset.
Note: Clicking this button also clears the service-level password.
Important:
- "Factory Default" in FW 7.72 → This FW does not change any network settings. In this FW version, it only defaults the camera settings, encoder settings, etc. Everything except the Network Settings.
- Starting with FW 7.80 → there are many more choices for Defaults and one of those would be to Default everything, including the network settings.
| Scroll only | ||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| ||||||||||||||
You are using an Offline Version of these Article, please ensure to regularly check the corresponding online article on the Bosch Building Technologies Knowledge Base for any updates. Use the date and version information of the document as reference. This is |
| Page Properties |
|---|