Panel controller displays can become de-calibrated, e.g. upon initial power-up followed by unintentional contact with the display or inaccurately touching the crosshairs. 

It becomes noticeable after the panel controller has re-booted and does not respond properly to touch.

Step-by-step guide

To re-calibrate the touch screen simply power down and power up the panel via the power switch on the right-hand side of the panel controller.  

Upon power up, place your finger immediately on the display until the boot menu appears. 

Once the boot menu appears, remove your finger from the display. You now have the option to either “Calibrate touch screen” or “Touch screen for at least 4 seconds to calibrate touch screen” (recommended).

You are now able to re-calibrate the touch screen.

MANDATORY --> after finishing this article, if you wrote advanced content in this section , you must to manually add the "advanced" label  This action is required to indicate that this article contains ADVANCED instructions for CTS/ SG or GK.

DO NOT CHANGE ANYTHING IN THIS SECTION!

IMPORTANT! --> the content itself from here will be not displayed. The content from here will be displayed only when the "ad" label will be set after article creation. Only CTS/ SG or GK are allowed to use "ad" label.

PLEASE do not set "ad" label from beginning. Use it only when you need this info and REMOVE the "ad" label when finished!

Information below is for CTS, SG, GK reference and must be kept internal only.

If you are part of CTS, SG or GK team, please hide this section when you have finished using this article!

DO NOT CHANGE ANYTHING IN THIS SECTION!

Type your text/ advanced information here

Please write here the statement/answer/explanation