| Scroll ignore |
|---|
| Scroll ignore |
|---|
Link visible only for L2 & L3 to be provided outside of Bosch Internal document. This article cannot be provided outside of Bosch. |
Step-by-step guide
Prerequisites:
- Santricity has been installed.
- E-Series has been scanned and added to Santricity.
Updating Controller Firmware:
- Open the Santricity software.
- Click on the Setup Tab.
- Click on Manage Storage Array.
- Click on the Support Tab and select Download Firmware.
- Select the type of firmware that requires the upgrade and choose “ok”.
The system will automatically perform a “Pre-Upgrade Check” before allowing the firmware download. Select “Ok” on the
“Pre-Upgrade Check” window.
On the Firmware Download page browse to the Controller firmware file, select the “Transfer NVSRAM File with Controller
Firmware” checkbox, browse to the NVSRAM file, and select “Transfer”.
Note: Files can be activated at a later time to provide minimal peak hour downtime.
| Scroll ignore |
|---|
Information below is for CTS, SG, GK reference and must be kept internal only. If you are part of CTS, SG or GK team, please hide this section when you have finished using this article! |
| Scroll only | ||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| ||||||||||||||
You are using an Offline Version of these Article, please ensure to regularly check the corresponding online article on the Bosch Building Technologies Knowledge Base for any updates. Use the date and version information of the document as reference. This is |