Cloud VMS

Alarm Management Configuration: How to connect AVIOTEC

AVIOTEC camera is a video-based fire detector with the capability of detecting both fire and smoke in the scene, it is also fully capable of running standard IVA rules in the camera.

When smoke or fire is been detected, AVIOTEC will sent a Smoke/Fire event to the Cloud VMS Alarm Management and at the same time trigger it’s output.  Using this output status, we are able to trigger the Cloud VMS/VSaaS Alarm Management .

Please make sure that these pre-conditions are met:

You have access to a VSaaS/Cloud VMS an Alarm Management instance

The AVIOTEC camera that you want to configure is connected to the Cloud VMS Alarm Management via Remote Portal

You have activated the appropriate Alarm Management license in Remote Portal for the respective AVIOTEC camera

You are running the latest firmware for the AVIOTEC. This example was tested with: 7.82.0025.

Step-by-step guide

Limitation:

1. There are 3 Fire profile in AVIOTEC, the default been “Fire”, this profile will not allow configuration of IVA rules in the camera. The other 2 profiles are called “Fire #1” and “Fire #2” these are profiles that works with both Fire/Smoke detection and IVA rules.  Please just use “Fire #2” profile that works with both Fire/Smoke detector and with IVA detections for Cloud VMSAlarm Management.
2. The output (relay) of the AVIOTEC will turn on when either Smoke or Fire has been detected, it will remain on if the Smoke or Fire still visible, hence, VSaaS Alarm Management will only be triggered once in such case.  The output (relay) will reset to off when there are no Smoke or Fire visible in the scene.
3. Regardless of how many fire spots have been detected, the output (relay) on the AVIOTEC will not retrigger when a new fire spot or smoke spot is been detected, it will remains on as long as there is one fire or smoke spot in the scene.

Below are the steps to configure both the camera and the VSaaS Alarm Management for Fire/Smoke Detection.

For details on how to setup the AVIOTEC camera for Fire/Smoke detection, please refer to the manual for details.   In the following example, we will be using “Fire #2” profile, the steps for “Fire” profile is the same, except that “Fire” profile does not allows configuration of IVA rules.

Step 1:

Goes to VCA->Main Operation.

Select “Fire #2” profile

Step 2:

Go to Fire Detection

Configure the Fire detection parameters as required.

Step 3:

Login to the VSaaS Alarm Management instance.

Navigate to the relevant site and add the device to the Cloud VMS Alarm Management (if not already done:   https://community.boschsecurity.com/t5/Security-Video/How-to-add-Remote-Portal-cameras-to-Bosch-Cloud-VMS/ta-p/49710)

Create a new VSaaS Alarm Management Service using Live Intervention.

Step 4:

Select the Trigger Device as the AVIOTEC camera, the Triggering Event as "Relay 1 ON" of the camera.

Select Always as the Arming Period.

Provide a self-explanatory Name for the service.

If there is a need to automatic or intervention actions, you will also need to configure it accordingly. Just an idea, you can create a pre-recorded voice message, such as “Fire or Smoke detected, please exit the building in an orderly manner” and use this as an audio announcement that could be triggered by the operator via the EVENTMONITOR web GUI.  

The audio file is loaded to the VSaaS Alarm Management and the action will play this audio file to any cameras in the site that has a speaker connected. This can be done using the Intervention action.